Product selection guides for industrial and commercial dehumidifiers. Compare different series, capacities, and configurations to choose the right model for your warehouse, cold room, greenhouse, or other project.
When choosing an industrial dehumidifier, you may notice that some models use R410A while others use R32 or R454B. Does the refrigerant make a difference, and which one should you choose? R410A is an established refrigerant, while R32 and R454B have a lower environmental impact if released into the atmosphere. However, the refrigerant also affects […]
A loading door opens at a warehouse. Warm, humid air enters, and water starts forming on a cold pipe, even though the room temperature looks normal. What changed? A psychrometric chart can help answer that question without guessing from relative humidity (RH) alone. A psychrometric chart brings temperature and moisture information into one picture. It […]
A room can show 55% relative humidity and still have water forming on a cold pipe, door frame or wall panel. The humidity sensor may be working normally. The problem is that relative humidity tells you how humid the air is at its current temperature, but it does not directly tell you whether a colder […]
Relative humidity is the percentage you see on a humidity meter, building controller or dehumidifier display. It looks like a simple number, but it is easy to misunderstand because the percentage changes with temperature. A room may show a lower RH after the heating is turned on even though no water has actually been removed, […]
An industrial dehumidifier can remove tens or even hundreds of litres of water per day. That water has to leave the unit continuously. If the nearest drain is below the unit and the pipe can maintain a downward slope, gravity drainage may be enough. If the discharge point is higher, the route cannot maintain continuous […]
Choosing the right electrical configuration is essential for an industrial dehumidifier. Matching voltage alone is not enough; phase, frequency, current, and connection requirements also need to match the actual site supply. This guide explains the common voltage and frequency combinations by market, when single-phase or three-phase power is used, how to check the nameplate and […]
Your information will be kept strictly confidential.
Our team would be happy to meet you and learn all about your business, requirements and expectations.
